| How to attend to this problem? We know that the P.C. power supply section is more absolute than DM8000, but it doesn't have the complaint of overheat given it uses air blower to save heat. Why not increase a or two fans onto DM8000? If you examination the DM8000 when you open it, you will find the location next to the 2.5 in. hard disk is only written to setup a fan. There is even a air blower power container nearby the position. Based on the size of the position, you should select the AVC 6015 air blower and the edge of the block should be 60mm, the density should be 15mm. If you have already got such a fan, only increase it onto the location and it will work without any other settings. When you open DM8000, you will see other air blower on the systemboard. This air blower won't work unless the heat of the appurtenance reaches a set worth or the appurtenance is starting. So you can use a plug-in to make the air blower run to be able to descend the temperature. First, you have to obtain the plug-in you need. In a few BBS on internet, there is a type of plug-in for Enigma2 called Fancontrol 2_2.1. Using this plug-in can attain the goal. After you got the IPK record of Fancontrol, you should give it to the TMP printed matter using DCC even though FTP. Then you can pull the blue symbol on the remote coordinator to obtain in to the blue surroundings borad. Search the record you only eliminated using the browser and when you find the record beneath the allocated catalogue, only pull the immature symbol on remote to setup it. Then you can run the plug-in. There will be a surroundings step if you use it is to initial time, you should set the air blower type to 4 pin and examine it using the yellow button. Now you will find the air blower is working. Using these two ways can help a lot in shortening the heat. Why not have a try now?
Comments | ||||||||||
| | ||||||||||
| | ||||||||||
| ||||||||||
Thursday, March 15, 2012
Computer Power Supply | How To Solve The Overheat Problem Of ...
Subscribe to:
Post Comments (Atom)





0 comments:
Post a Comment